How to Replace the SodaStream Quick Connect Cylinder in my SodaStream GAIA™ Sparkling Water Maker?

It’s easy to get the sparkling started with our SodaStream Quick Connect Cylinder. Just follow the instructions below to get bubbling!

* The cylinder handle might be either Black or Pink.

** The SodaStream Quick Connect CO2 Cylinder has a new fresh design - Same trusted quality!

1. Place the SodaStream GAIA™ Sparkling Water Maker on a flat sturdy surface in an upright position and pull open the back cover.
2. If a carbonating bottle is inside, remove the bottle. Never insert or replace the cylinder while a carbonating bottle is in SodaStream GAIA™ Sparkling Water Maker.
3. Remove the seal and cap from the SodaStream CO2 Quick Connect Cylinder.
   
   WARNING!
   Never insert or replace the CO2 Quick Connect Cylinder while a Carbonating Bottle is installed in the Sparkling Water Maker. This can cause the Carbonating Bottle to burst.
   
   
4. Raise the cylinder handle. Insert the SodaStream CO2 Quick Connect Cylinder in the back of the Sparkling Water Maker. Bottom first!
5. Lower the cylinder Handle.
6. Reinstall the back cover by fitting the upright tab at the bottom into the rear slot at the base of the Sparkling Water Maker. Then push the cover into place onto the back of the Sparkling Water Maker.