It’s easy to get the sparkling started with our SodaStream Quick Connect Cylinder. Just follow the instructions below to get bubbling!
Sparkle Note: The SodaStream ART™ Sparkling Water Maker is compatible only with the SodaStream Quick Connect Cylinder, so make sure your cylinder comes with a wrap bearing the Quick Connect logo.
** The SodaStream Quick Connect CO2 Cylinder has a new fresh design - Same trusted quality!
- Place the SodaStream ART™ Sparkling Water Maker on a flat sturdy surface in an upright position.
- If a carbonating bottle is inside, remove the bottle. Never insert or replace the cylinder while a carbonating bottle is in the SodaStream ART™ Sparkling Water Maker.
- Remove the back cover by pulling it away from the body of the Sparkling Water Maker while placing one hand on top of the Sparkling Water Maker.
- Raise the cylinder handle.
- Remove the seal and cap from the SodaStream Quick Connect Cylinder. Insert the cylinder into the cylinder holder by positioning the bottom of the cylinder into the Sparkling Water Maker and then gently placing the rest of the cylinder into the cylinder holder.
- Lower the handle.
- Replace the back cover by fitting the upright tab at the bottom into the rear slot at the base of the Sparkling Water Maker. Then push the cover into place onto the back of the Sparkling Water Maker.
Questions? Contact us via email or phone at 1-877-436-5866.